A dryer that will not heat or will not start throws off the whole laundry routine. We book same-day and next-day dryer visits across Northern Virginia.
Yes, we repair dryers, and in most cases we can be at your door the same day or the next. A technician diagnoses the fault, then gives you a firm price before any work begins. Call (571) 357-5201 to book.
We work on electric and gas dryers, vented and condenser units, including stackable and compact models, and the truck is stocked for the failures we see most, so most jobs finish in one visit. If it turns out to be the washer acting up instead, see our washing machine repair page.
When the drum turns but the clothes come out just as wet as they went in, the heat side of the machine has failed while the motor side has not.
Heating element (electric) or igniter (gas). This is the part that actually produces heat. On an electric dryer it is a coil that glows red; on a gas dryer it is an igniter that lights the burner. Either one can fail outright.
Thermal fuse. A one-time safety fuse that blows when airflow is restricted for too long. Once it trips, the dryer runs cool no matter what else is working, until the fuse is replaced.
High-limit thermostat. Sits near the heat source and cuts power if the air gets too hot. A failed thermostat can cut heat early in the cycle even when nothing else is wrong.
Blocked vent or lint restriction. Not a broken part at all, but the most common root cause behind the other three: restricted airflow overheats the system and trips the safety devices meant to protect it.
We check those in that order on the visit. Call (571) 357-5201 and we will tell you what we find first.
A dryer that does nothing when you press start is usually a simple safety interlock or power problem, not a major failure.
Door switch. Every dryer refuses to run if it does not sense the door is fully closed. A worn or misaligned switch can read as open even when the door is shut.
Start switch. The physical button or switch that kicks off the cycle wears out with use, especially on older units, and can fail even though everything downstream of it is fine.
Thermal fuse. The same fuse that stops heat can also cut power to the whole unit on some models, so a dead dryer and a cool dryer sometimes share the same root cause.
Power supply. Electric dryers run on a dedicated high-voltage circuit. A tripped breaker, a loose connection at the outlet, or on some installs a blown half of a two-pole breaker can leave the drum motor with no power at all.
We can usually sort out which it is in one visit.
Here is what Northern Virginia homeowners have said about us on Google.
Tell us what the appliance is doing and we will get a technician out, usually the same day or the next.
Three steps, no surprises in the middle.
Your technician listens to what the appliance is doing, then tests the parts that actually cause that symptom. No guessing, and no swapping parts to see what sticks.
You get the price for the repair before any work starts. If you would rather not go ahead, that is fine, and nothing happens without your say-so.
Most jobs finish in one visit, because the van is stocked for the failures we see week in and week out on common brands and models.
Electric and gas dryers share most of their moving parts, but the heat source is different, and vented and condenser units handle moisture differently too. We work on the full range.
We service all major brands and models, including Whirlpool. Our technicians train continuously as manufacturers change platforms, so a newer moisture sensor or a proprietary control board is not a reason to send you elsewhere.
It starts with a diagnostic visit. The technician finds the actual fault, then gives you a firm price, and you decide before any work begins. As a rule of thumb, repair makes sense well under half the cost of replacing.
Most of the time, the same day or the next. We take appointments six days a week across Northern Virginia. Call (571) 357-5201, tell us what the appliance is doing, and we will find you the earliest slot we have.
Most often a failed heating element or igniter, a blown thermal fuse, or a tripped high-limit thermostat. A blocked vent is frequently the reason one of those parts failed in the first place, so we check airflow along with the part itself.
This is almost always restricted airflow, either a clogged lint screen, a blocked vent run, or a moisture sensor that is no longer reading correctly. It is rarely the heating element if the dryer is still producing some heat.
Dryers are one part of what we do. We also repair refrigerators, washing machines, dishwashers, and ovens and stoves, the same way every time: diagnose, agree the price, then do the work.
We cover Northern Virginia, and we will tell you up front if you fall outside the range. Call (571) 357-5201 or request service online and we will get a technician scheduled.
Fill out the form below and we'll get back to you shortly.
This will close in 60 seconds